PCB Design — Cleveland, Ohio
PCB Design That
Survives Production.
Schematic capture, board layout, power electronics, and low-noise analog — designed for manufacture from the first trace, with clean handoff to U.S. board houses. Senior engineers only.
Kyros Engineering provides PCB design services in Cleveland, Ohio — schematic capture, board layout in Altium or KiCad, power electronics, low-noise analog and mixed-signal design, and EMC-aware layout — delivered production-ready with fabrication and assembly packages for U.S. board houses.
PCB Design Services in Cleveland, Without the Body-Shop Model
Kyros Engineering designs printed circuit boards from our Cleveland, Ohio office for clients across Northeast Ohio and nationwide. We are an engineering firm, not a fab: every board is designed by a senior engineer who has taken products through EMC chambers, production ramps, and field failures — and designs so you avoid all three biting you.
Local matters for board work. When bring-up hits a wall, we put the board on our bench — or bring the scope to your plant in the Cleveland, Akron, or Mentor area — instead of debugging over a webcam. Respins and rescues of existing boards are a large share of our work: we root-cause first, then fix the actual problem rather than re-laying-out on instinct.
For fabrication and assembly we maintain a current pricing benchmark across ten U.S. board houses, so your design lands at a shop matched to its volume, tolerances, and compliance needs (including ITAR-sensitive work that cannot go through offshore self-serve portals). You own the design files outright — Altium or KiCad, your call.
What We Design
Boards for Hard Environments
Power Electronics
Inverters, motor drives, battery management, and high-current layout with thermal design that holds up in the field.
Low-Noise Instrumentation
Analog front ends, precision sensing, ΔΣ converters, and grounding discipline for signals that live below a millivolt.
Digital & Mixed-Signal
Microcontroller and embedded-compute boards with signal-integrity-aware routing, stackup design, and connectivity.
DFM & Board-House Handoff
Design-for-manufacture reviews and complete fab/assembly packages — we coordinate vetted U.S. board houses for you.
Real Project
Portal — Smart EV Charger
Kyros Engineering — Power electronics and control board for a connected Level 2 EV charging product
Frequently Asked Questions
- How much does PCB design cost?
- Simple 2-4 layer boards typically run a few thousand dollars; complex mixed-signal, power, or high-speed designs run roughly $10K-$40K including schematic, layout, DFM review, and fab/assembly handoff. We quote fixed-price after a short architecture review.
- Do you also fabricate and assemble boards?
- We design; fabrication and assembly run through vetted U.S. board houses that we coordinate for you, matched to your volume, tolerances, and compliance needs — including ITAR-sensitive work that cannot go through offshore self-serve portals.
- Can you rework or respin an existing board?
- Yes. Respins and rescues are a large share of our work: we root-cause the failure on the bench first — power, signal integrity, EMC, or firmware interaction — then fix the actual problem instead of re-laying-out on instinct.
- Do you design in Altium or KiCad?
- Both. We work in your toolchain so you own the design files outright, with libraries and fab outputs organized for your team to maintain after handoff.
Ready to Talk Through Your Build?
Tell us what you're building. We'll schedule a free consultation to discuss architecture, timeline, and budget — with an engineer, not a salesperson.
Talk to Our Founder